|
- retain
Fender clean sound
- add
a lead channel without sacrificing tremolo
- both
channels get reverb/tremolo (where available)
- use
in any 2-channel Fender amp built on eyelet boards
(up to mid-1980s)
This
mod is easily applied to any Fender amp with a 'Normal'
channel and a 'Vibrato-Reverb / Bright / Deep' channel,
each with its own EQ. When completed, you'll have
the same clean sound, but now you can dial up an over-drive
or distortion tone. This can be tailored to your own
taste from 'mild' to 'hot', 'domestic' to 'European'.
Adding
the Electronic Shunt Relay Kit
allows remote selection through a footswitch.
All
resistors and capacitors, and the drive control are
supplied. The mod uses the existing pair of dedicated
preamp tubes. Both of the new sounds go through the
reverb and tremolo (where available).
|
Ordering
Information